Initial Setup Steps for Identity Provisioning with Egnyte

This page describes the initial setup steps for using TrustLogin as the source of identity
to perform Identity Provisioning to Egnyte.

Note: For detailed instructions on operating Egnyte, please refer to the documentation provided by Egnyte.

Item	Details
Pre-check	Egnyte administrator privileges are required.
Setup Flow / Manual	Egnyte Settings TrustLogin Settings Values You Can Configure in Attribute Mapping Note: After connecting TrustLogin and Egnyte using the steps on this page, 　please proceed to configuring user synchronization.
Provisioning Target	〇	Supports user provisioning
	〇	Supports group provisioning
SAML Authentication Setup Manual	－
Notes	None in particular

Setup Steps

Click the token generation URL "https://scim-20.egnyte.com/".
Enter the Egnyte subdomain you are using, and click "Generate Token".
Click "OK".
Click "Allow Access".
Copy the displayed API Token.
Note: The token cannot be viewed again after you "Save". Please make sure you have copied it before proceeding.

This completes the preparation on the Egnyte side. Next, configure the settings on the TrustLogin side.

Log in to the TrustLogin Admin Page, and from the "Admin Page > Settings > Optional Features" menu,
open "Settings" next to "Identity Provisioning".
Click "Add Service".
On the Add Service screen, search for and select "Egnyte", then click the "Add" button.
You will be redirected to the "Identity Provisioning > Egnyte" page.
Click the "Edit" button.

Open "Access Settings", enter the following values for the settings items, and click "Save".

Connection URL	https://<domain_name>.egnyte.com/pubapi/scim/v2 <domain_name> is the Egnyte domain to connect to Note: Please specify the Egnyte environment (domain) you are using.
Access Token	The value of the "API Token" you copied in step 5 of Egnyte Settings

Next step: The manual for configuring user synchronization is available here

You can map any attribute on the TrustLogin side to any attribute on the Egnyte side.
For configuration instructions, see here

Setup Steps

Egnyte Settings

Click the token generation URL "https://scim-20.egnyte.com/".

Enter the Egnyte subdomain you are using, and click "Generate Token".

Click "OK".

Click "Allow Access".

Copy the displayed API Token.
Note: The token cannot be viewed again after you "Save". Please make sure you have copied it before proceeding.

This completes the preparation on the Egnyte side. Next, configure the settings on the TrustLogin side.

TrustLogin Settings

Log in to the TrustLogin Admin Page, and from the "Admin Page > Settings > Optional Features" menu,
open "Settings" next to "Identity Provisioning".

Click "Add Service".

On the Add Service screen, search for and select "Egnyte", then click the "Add" button.

You will be redirected to the "Identity Provisioning > Egnyte" page.
Click the "Edit" button.

Open "Access Settings", enter the following values for the settings items, and click "Save".

Connection URL	https://<domain_name>.egnyte.com/pubapi/scim/v2 <domain_name> is the Egnyte domain to connect to Note: Please specify the Egnyte environment (domain) you are using.
Access Token	The value of the "API Token" you copied in step 5 of Egnyte Settings

Click the "Connect" button in the upper right of the screen.

Once the button status updates to "Connected", the initial setup is complete.

Next step: The manual for configuring user synchronization is available here