This page describes the initial setup steps for using TrustLogin as the source of identity
to perform Identity Provisioning to Netskope.
Note: For detailed instructions on operating Netskope, please refer to the manual provided by Netskope.
Item |
Details |
|
Pre-check |
|
|
Setup Flow / Manual |
Note: After connecting TrustLogin and Netskope using the steps on this page, |
|
Provisioning Target |
〇 |
Supports user provisioning |
〇 |
Supports group provisioning | |
SAML Authentication Setup Manual |
How to Configure SAML Authentication for Netskope (Admin Page)
|
|
Notes |
|
|
Setup Steps
Netskope Settings
-
Log in to Netskope with administrator privileges.
From the management console URL, note down the tenant name portion shown below.
- Click "Setting".
- Go to "Administration ＞ Administration & Roles",
then click "Service Account" on the "Administrators" tab.
-
Configure each item with the following information.
Service Account Name Any name of your choice Role Select "Custom SCIM Role" REST API Token Any token expiration period of your choice Note: The settings shown in the image are just an example. Please check with Netskope for the actual configuration details.
- Click the "Create" button.
- A token will be created.
Copy the displayed "API Token" value. (This will be used in the TrustLogin settings)
Note: The token cannot be displayed again. Please make sure to copy it without omission.
This completes the preparation on the Netskope side. Next, configure the settings on the TrustLogin side.
TrustLogin Settings
Log in to the TrustLogin Admin Page, and from the "Admin Page > Settings > Optional Features" menu,
open "Settings" next to "Identity Provisioning".
- Click "Add Service".
- Select "Netskope" and click the "Add" button.
- You will be redirected to the "Identity Provisioning ＞ Netskope" page.
Click the "Edit" button.
-
Open "Access Settings", enter the following values for the settings items, and click "Save".
Connection URL Netskope Settings The management console URL you copied in Step 1 Access Token Netskope Settings The token you copied in Step 5
- Click the "Connect" button.
Once the button status updates to "Connected", the initial setup is complete.
Next step: The manual for configuring user synchronization is available here
Values You Can Configure in Attribute Mapping
The values that can be specified as default functions for Netskope are as follows.
| Value | Description |
| Full Name | The full name with the last name first. |
| Full Name with First Name First | The full name with the first name first. |
| Username from Email Address | Takes the part of the email address before the @ and limits it to a maximum of 21 characters. |
Note: For an overview and configuration instructions for the attribute mapping feature, please see here.